ESE Lightning Rod Tester with Fast Response

Golden Smart TSTLP^® ESE lightning arrestor tester is designed to check that the main components of the upgraded TSTLP^® ESE Lightning Arrestor are working properly and that none of the vital components is damaged (Results are given by both Green/Red light and ringing WARNING signal).

- Available to use with Portable Power Bank for convenient use on site.

1: Connecting the tester with Power by the Power adapter (110V/220V/230V - 9V) or with 9V Portable Power Source.

2: Insert the alligator clips into OUTPUT terminals (+/- could be exchanged)

3: Clamp the one alligator to the central rod of the TSTLP^® ESE terminal

Make sure making correct connections:

1: Connecting the tester with Power by the Power adapter (110V/220V/230V - 9V) or with 9V Portable Power Source.
2: Insert the alligator clips into OUTPUT terminals (+/- could be exchanged)
3: Clamp the one alligator to the central rod of the TSTLP^® ESE thunder arrestor

LOW ELECTRODES TEST:
After above 1,2,3 connection, clamp THE OTHER ALLIGATOR to one of the lower electrodes of the TSTLP^® ESE lightning arrestor, press button SWITCH, Power Indication Lamp’s on, press T, it’s working OK if T & LOW-OK indication lamps’ on,which makes long-voice. It’s faulty if DEF indication lamp’s on,which makes several short-noise. Repeat same operation steps to rest lower electrodes till finished.

UPPER ELECTRODES TEST:
After above 1,2,3 connection, clamp THE OTHER ALLIGATOR to one of the upper electrodes of the TSTLP^® ESE lightning arrestor, press T, it’s working OK if T & UP-OK indication lamps’ on,which makes long-voice. It’s faulty if DEF indication lamp’s on,which makes several short-noise. Repeat same operation steps to rest upper electrodes till finished.

Meanwhile, Successful Full Series General, Mechanical, Environmental, Electrical & Early Streamer Emission Tests according to NF C 17-102:2011 Annexe C (UNE 21.186:2011 Paragraph C) standards @ ILAC Member Accredited Labs in Spain & Romania, Europe are ALSO available.