TS-POE5 POE Surge Arrester

Model 

TS-POE5 

RJ45 interface 

Power Supply line 

Nominal voltage 

Un

5V- 

48V- 

Rated voltage (max. continuous voltage) 

Uc

6V-

60V- 

Nominal discharge current (8/20) 

In

2KA (line-line)

2KA (line-PG) 

3KA

Combination wave (10/700)

Uoc

6KA (line-line)

6KA (line-PG)

---

Voltage protection level at In 

Up

≤60V (line-line)

≤60V (line-PG) 

≤200V 

Response time 

t_A

≤1ns (line-line)

≤1ns (line-PG)

≤25ns

Bandwidth

f_G

165Mbits/s

---

Max. data transmission rates

Vs

100Mbits/s

---

Protection lines

1 / 2 / 3 / 6

4 / 5 (+). 7 / 8 (-)

Operating temperature range

-40°C...+80°C

Relative humidity

≤95% (25°C)

Connection (input / output)

RJ45 shield socket

Shield earthing

Screw terminal

Enclosure material

Aluminum

Standards

IEC 61643-21; GB 18802.21; YD/T 1542

Certification

CE(EMC,LVD)

INSTALLATION INSTRUCTION 

1. This POE Surge Arrester is connected in series to the protected device.

2. The out terminal should be connected to the protected devices.

3. SPD's earthing terminal must be connected to nearby earthing BusBar or the metal earthing enclosure of protected device.

4. After above, you should ensure the circuit is functioning.

Regularly inspect the operating status, especially after lightning. Once the communication is off, electrician should check/replace the SPD.

INSTALLATION DIAGRAM

WARNING:

1, The device must be installed by electrically skilled person, conforming to national standards and safety regulations.

2, It is recommended that installation should be done under power off condition.